Rails Clamps for Tee Rails 20-lb, 25-lb, 30-lb, 40-lb, 60-lb, 80-lb and 85-lb

Previous
Next Next Page

Rail Clamps for Tee Rails 20-lb. to 85-lb.

Rail Clamps with Eccentric Fillers

Single Clamp (One Filler Per Clamp)	Double Clamp (Two Fillers per Clamp)

Eccentric Filler

Note: 13/16" Diameter Holes Are Standard

Rail Section	Bolt Gage	Single Clamp No.	Double Clamp No.
20AS	5 1/8"	201	202
25AS	5 1/4"	251	252
30AS	5 5/8"	301	302
40AS	6"	401	402
60AS	6 3/4"	601	602
80AS	7 1/2"	801	802
85AS	7 11/16"	851	852

For conditions not listed, please specify

A. Rail weight and section

B. Bolt Gage

C. Bolt centers for double clip

D. Bolt size (diameter) or hole size

E. Length of clip

F. If worn rail, width, thickness, and taper of rail base.

Clamps with eccentric fillers are used where small gage adjustments are required. Through positioning of the eccentric fillers, the adjustment range is 3/16 in. Both single clamps (with one eccentric filler per clam) and double clamps (with two fillers per clamp) are available for rail weights of 20 to 85 lbs.

DID YOU KNOW
that Harmer Steel

Thank you for visiting our web site. We value you highly as one of our customers. If there is anything we can do to assist you, please don't hesitate to contact one of our knowledgeable sales representatives.

This material has been printed from an internet page currently located at:
www.harmersteel.com /catalog/3/10/rail_clamps_tee_rails.shtml
Printed from IP address: 38.103.63.18on Saturday, 05-Jul-2008 22:38:17 MDT