Turnout Diagram for Rails used in Railroads, Cranes, Mines, and Tunnelling

Previous
Next Next Page

Standard Complete Turnout

The following pages show the standard design of various components that make up a turnout. Designs shown are those most commonly specified, and can be modified to accommodate individual requirements. Turnouts for mining and tunneling applications can be mounted on steel ties and preassembled, or they can be piece-marked and shipped in components for assembly on site. Steel tie sets consisting of special steel ties for the switch and frog are also available. These tie sets eliminate the need for numerous slide plates and rail braces and are much faster to install than a turnout on wood ties.

Track-Work Formations
Diamond Crossing	Left Hand Crossover	Straight Crossing
Left Hand Turnout	Double Hand Crossover	Right Hand Turnout
Equilateral Turnout	Right Hand Crossover	3 Way Turnout

DID YOU KNOW
that Harmer Steel

Thank you for visiting our web site. We value you highly as one of our customers. If there is anything we can do to assist you, please don't hesitate to contact one of our knowledgeable sales representatives.

This material has been printed from an internet page currently located at:
www.harmersteel.com /catalog/5/01/introduction_turnout_diagram.shtml
Printed from IP address: 38.103.63.18on Friday, 18-Jul-2008 19:06:48 MDT